this is taken straight from the instructions from upgrading to keysoft 7.0. this applies also to 7.01. hth paul.
?Upgrade Procedure. Ensure the BrailleNote is plugged into the AC Adapter and switched on, and the SD card provided is inserted in the card slot on the back of the BrailleNote. If you have a software only SMA then ensure that you have followed previous instructions on formatting, downloading and copying the appropriate files to a SD card. Ensure that there is no cards in the other slots, the CF and PCMCIA. Hold down dots 4 & 6 on the Braille keyboard (keys J and L on Qwerty versions) and press the reset button on the left side of the unit, just behind the on/off switch. Keep holding the 4 & 6 dots (J and L on the Qwerty) until the unit makes a sound, at which point you can release the held down keys. You should then hear a rising series of 4 notes something like "diddle lee dee". Press dots 1 and 2 (the 2 key on the Qwerty) and you should hear a series of tones, completing within 3 to 5 seconds with a similar "diddle lee dee" series and then silence. Press and hold dots 4 & 5 (J & K on Qwerty) and once again press the reset button on the side of the unit. Keep holding down dots 4 & 5 until you hear some sound. The Braille display will show the word "Loading". At the completion of the beeps (about 10 to 15 minutes), the unit will reset and you will be placed back into Keysoft fully upgraded and ready to go. ___ To leave the BrailleNote list, send a blank message to [EMAIL PROTECTED] To view the list archives or change your preferences, visit http://list.humanware.com/mailman/listinfo/braillenote
