Hi list.
I have my flash disk back now but it says cannot load planner. just
in case anyone has this problem where the pk cannot access the flash
drive this is what you must do. I ran the hyper terminal program
called braille note visual display.ht
connect the pk to com 1 or com 2 on your pc.
now press c1 and c4 to switch the pk off. in the program from the
desktop go to new and call it pk
then on the next screen tell it if it is on com 1 or com 2.
now the bits per second should be set to 38400
flow control should be set to hardware.
then press o.k.
now hold the escape down on your pc and press c1 and c4 on the pk
wait thirty seconds for nothing to happen you should not get keysoft to load.
now if this is so release the escape on the pc and in the terminal
program type the following
epsm and press enter
ereg press enter
now do a c1 and c4 and unplug the cable.
again do a c1 and c4 on the pk and all should be well.
all is not well as I had to install my gps again and I cannot get the planner.
I am sure there is a re-set to do this wonder if someone can help.
sorry about the long post but it saves sending the unit back.
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
