On a BT Braillenot model it is spacebar with dots 1 5 6. When I use this
command, I know where a particular character will show on a 40 space line.
You need only proof your document so you know the braille is correct! Check
for number of pages or for where page breaks occur. Sometimes one might get
premature page breaks and these need to be edited out. Use the "edit mode"
when proofing your document. You will see all the new line commands, page
breaks, centering etc.
Jim Aldrich
----- Original Message -----
From: "Taraprakash" <[EMAIL PROTECTED]>
To: "Braillenote List" <[email protected]>
Sent: Thursday, October 19, 2006 1:05 PM
Subject: [Braillenote] prview in Bn documents
Hi all.
I never used braille displays earlier. This question may sound dumb but I
won't know unless I ask. So here I go.
I want to use my BN to write braille documents and later to be embossed in
40 cell setting. if I am using 32 cell display on my BN how can i get an
exact preview of my braille document on my bn braille display?
How will I know where will the line will end in actual embossed documentor
how will it look on paper?
Hope I am clear.
Thanks for any suggestions.
Regards
Taraprakash
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
