Cindy, I assume you cannot use this card. It didn't mention
ethernet cf card. This is how the instructions read:
Socket Rugged Ethernet Card Driver
The original Socket Low-Power Ethernet CF card is no longer
freely available on the market, but a replacement card is
available -- the Socket Rugged 10/100 Ethernet CF card. However,
to use this card with KeySoft Version 7.2 or earlier, you must
first install the necessary driver software, which HumanWare has
released as a separate software package.
Please read the instructions below carefully before proceeding.
The package contains two files:
1. Installer dot exe, which allows new driver files for
various cards to be installed.
2. Rugged dot exe, which contains the drivers for this
particular card.
The first part will be incorporated in KeySoft at the earliest
opportunity, but until then you will need to run this file before
installing drivers for the very first time. You only need to run
this file once -- so if you install further sets of drivers for
different cards, you don't have to run installerddexe again.
(Don't worry if you accidentally run it again, it won't cause any
problems.)
The second part contains the driver files for this specific
card. When you run rugged dot exe, the files are copied to your
Flash Disk so you won't lose them if you perform a 4-5-6 or
service reset, or let the unit run out of battery power
___
Replies to this message will go directly to the sender.
If your reply would be useful to the list, please send a
copy to the list as well.
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
