Hello fellow braillenote users,
If I turn the braillenote mpower off with an sd card in the slot, and
then turn the unit on sometime later, and try to play an mp3 file, the
file will start to play, but within a matter of two seconds of me
pressing enter to start the file, I get the error alert tone, followed
by "class not registered." What does this mean? I've found that if I
reboot the machine, and then try to play the same file again,
everything works fine. I've never seen this before. What could be going
on? I know for a fact, that the sd card, is in read/write mode. When I
hold the card so that the cutoff edge is facing me, and the ridges are
facing down, there's a tinny little slot on the left side of the card,
and a similar but slightly bigger slot on the right side of the card.
I've been messing around trying to find the so-called slider switch
that allows us to change between read only and read/write modes, but I
still haven't been able to find it. Could it be, that I've somehow
moved this switch without realizing it? which in turn would cause this
strange message to keep coming up when I play a file from the sd card?
Mike
Rochester, NY.
___
Replies to this message will go directly to the sender.
If your reply would be useful to the list, please send a
copy to the list as well.
To leave the BrailleNote list, send a blank message to
[email protected]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
