Chuck, Have you established the partnership while connected via serial port and then run the bnipconfig.exe program to program the bn with the correct parameters from your pc?
I am successfully using activesync connecting to the bn via the ethernet card here. Also, after you set the parameters for the bn be sure to disconnect activesync and also look in connection settings within activesync to be sure you have all the boxes checked properly. I uncheck the box telling activesync to look on serial port and check the one for activesync to use the network. Finally, I've found it's a good idea to do a simple reset of the bn after you program it with the parameters from bnipconfig.exe. I hope this is enough info to help you out. If I can assist further, don't hesitate to let me know. Don On Sat, 20 Nov 2004 19:39:17 -0500, Chuck Pettke wrote: I am currently using the BrailleNote QT with KeySoft 5.1 build 22 and ActiveSync v3.71. build 4034. I am running on a Windows XP with service pack 2 installed and am having problems connecting to ActiveSync with an ethernet card. I have the CP ethernet card recommended by Pulse Data and have followed the proceedures to connect via ethernet (i.e. I have followd the steps outlined in appendix D section D1 "Instructions for Setting Up Networking" and still no luck. What am I missing? This worked fine with Windows 98 so I am assuming there is some issue with Windows XP. I am also using a Linksys Broadband Firewall Router model BEFSX41Firmware Version: 1.50.18 Any help is greatly appreciated. Thanks in advance. This list is great! I've already gotten some questions answered by just reading the posts. ___ To leave the BrailleNote list, send a blank message to [EMAIL PROTECTED] To view the list archives or change your preferences, visit http://list.pulsedata.com/mailman/listinfo/braillenote
