I have received the message about new visible connection. I have tried going to the internet and to the pulsedata website but it does not connect.
Marianne ----- Original Message ----- From: "Don Bishop" <[EMAIL PROTECTED]> To: "Braillenote List" <[email protected]> Sent: Friday, May 20, 2005 9:55 PM Subject: Re: [Braillenote] problem with wireless connectivity > Hi Marianne, > > I probably should have included this in my previous message. > > When you find your network and press enter it will often say new visible network and this is fine. It may even do this when you try to connect to it in the > future. Sometimes it won't say it though for some reason. > > Anyway, when the connection starts you should get a prompt saying "connecting to" followed by the name of your network configuration. > > This will usually come after a "please wait" message which can last several seconds. > > The connecting message can also last several seconds as the router and bn are attempting to establish the connection. > > After several seconds, if all is well, you should see a message like "connected to" followed by configuration name. > > Once you see the "connected to" message you're in. > > Then, wait a couple seconds (not sure if it's really necessary but I do it anyway), and then escape back to the main menu. > > The first time I'd just try connecting to the internet as that's the most straightforward. Just hit i from the main menu and then enter to see if you can commect > to www.pulsedata.com which is the default. > > You'll be asked which connection to use and make sure you select the configuration name of your wireless configuration and hit enter. After tat first time, > this will show as the default connection each time you do connect until you select a different configuration. > > Finally you should see the pulsedata page in a few seconds. > > Hope this gives you a better idea of what you should be looking for when you try to connect. > > Don > > On Fri, 20 May 2005 21:18:18 -0400, marianne denning wrote: > > I have Braillenote BT version 6.11 build 26. I purchased a Cisco Aironet 350 card. I put it in, went to options, to connectivity, to wireless and had > it scan for our network at home. It found the network. Every time I hit enter It says the operation was completed successfully but I cannot go any further. > An email from Don suggested disabling all security on the router which we did and the same thing keeps happening. It is now telling me there is a new > visible network. Does anyone have any suggestions? > ___ > To leave the BrailleNote list, send a blank message to > [EMAIL PROTECTED] > To view the list archives or change your preferences, visit > http://list.pulsedata.com/mailman/listinfo/braillenote > > > > > > ___ > To leave the BrailleNote list, send a blank message to > [EMAIL PROTECTED] > To view the list archives or change your preferences, visit > http://list.pulsedata.com/mailman/listinfo/braillenote >
