The reason the group is not hot is probably because the brew boiler is not full. It has to be full to allow the water to circulate from the top of the boiler, through the group and then down to the bottom of the boiler.To start, make sure the lever is in the down (not middle) position or water will leak out of the brew group. It may also be a problem with water leaking by the OPV valve and going back into the reservoir. To check this remove the tube from the resrvoir and put it into a dry cup, It will leak a little while it is heating up but then it should stop.Also on start up raise the lever up and run a couple of ounces through the brew group to make sure the boiler is full.Let us know how you are making out.ThanksTodd SalzmanWhole Latte Love understand that with HX machines users have to flush to take group'stemperature down.I am experiencing the opposite. Usually, when I leave the machineidling for a while the group's temperature just feels warm/hot. Then,I flush it a bit and a few minutes later, it is burning hot. Is thisnormal with double bolier machines?I know that water circulates inside the E61 group. Does it happenwhile a shot is being pulled? if not when?Thanks
-- You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/brewtus?hl=en.
