The water coming out comes from both the Air Remover and the OPV which are both
located on the outlet of the pump. Both are necessary parts. If you take off
the 5 screws that hold on the housing and then remove the housing you will be
able a plastic tee that leads to the chrome tube. Just get a piece of rubber
hose from a hardware store and run it back to the reservoir.
Todd Salzman
Whole Latte Love
--
You received this message because you are subscribed to the Google Groups
"Brewtus" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/brewtus?hl=en.
--- Begin Message ---
Vibe pump and reservoir. OK, so I can send it back to the reservoir?
kl. 23:16:57 UTC+2 fredag 10. august 2012 skrev Ira følgende:
>
> At 01:59 PM 8/10/2012, you wrote:
> >I have a question concerning the elbow pipe. What is the purpose of
> >it? It is constantly pouring out cold water while brewing.
>
> Do you have a rotary or Vibe pump? Plumbed or reservoir?
>
> It's the excess water. If it's rotary and plumbed it's just the way
> it is. if it uses a water tank and the water coming out is cool, you
> should in theory be able to re-route it back to the tank like it was
> in the earlier versions.
>
> Ira
>
>
--
You received this message because you are subscribed to the Google Groups
"Brewtus" group.
To view this discussion on the web visit
https://groups.google.com/d/msg/brewtus/-/TvqY4pWh3pUJ.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/brewtus?hl=en.
--- End Message ---
