Hi All, I have my rpm pump and Fluid o Tech Rotoflow pump. The pump is slightly longer than the one WLL have sourced, and while it will just fit I think I just wanted to ask if it has to be installed as shown, can you mount the pump vertically with the inlet/outlet exiting horizontally?
I can't imagine why not as I'm running it plumbed in so it will always be fed by posative pressure. I may just re-locate the main Gicar control unit which will make sure there's room but wanted to ask so I have options. Thanks. On Thursday, 8 August 2013 13:12:40 UTC+1, Enders13 wrote: > > Thanks Todd, > > Pump and motor ordered, as are the vibe isolation feet, just sourcing > check valve and feed lines now, much harder to come by in 1/8 and 3/8 > sizing in the uk but there are suppliers, i'm just looking for the best > deals > > > On Thursday, 8 August 2013 03:08:32 UTC+1, Todd Salzman wrote: >> >> Attached are instructions on how to make the conversion. >> The motor listed is 110 Volts but you should be able to source one in >> Europe from any retailer that has parts for the Brewtus. >> >> Todd >> Whole Latte Love >> >> >> On Wed, Aug 7, 2013 at 6:31 PM, Enders13 <[email protected]> wrote: >> >>> Did you sort your conversion Ben? >>> >>> I've done the PID and just Ordered an RPM slimline motor and Rotoflow >>> pump which has two 3/8 female connections. I've a few ideas for an inline >>> check valve then the rest is just fittings to connect inflow and outflow, >>> I'm told that gas fittings are the place to look but would like someone in >>> the UK to give a heads up on fittings suppliers. >>> >>> On Thursday, 28 February 2013 08:48:19 UTC, Kaffebohne wrote: >>>> >>>> >>>> I've recently picked up a Brewtus tank/plumb with a vibe pump (Leva >>>> Dual Boiler here in Europe) and have already gone from tank to direct >>>> plumb. >>>> >>>> Now I would like to convert it from vibe to rotary pump and I have a >>>> few of questions: >>>> >>>> - Is there a supplier of 220-240v rotary pump conversion kits around? >>>> If not, does anyone have a complete parts list for the conversion? >>>> - once the machine is direct plumbed with the rotary pump, what is >>>> holding back the water pressure when the machine is turned off? Is it >>>> just >>>> the brew group or is there a solenoid closer to the water source? >>>> >>>> Cheers, >>>> >>>> Ben >>>> >>> -- >>> You received this message because you are subscribed to the Google >>> Groups "Brewtus" group. >>> To unsubscribe from this group and stop receiving emails from it, send >>> an email to [email protected]. >>> To post to this group, send email to [email protected]. >>> Visit this group at http://groups.google.com/group/brewtus. >>> For more options, visit https://groups.google.com/groups/opt_out. >>> >>> >>> >> >> -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/groups/opt_out.
