Thanks again James. Will check that too. Just replaced the power switch too. I did find a guy close to me who repairs control boards, so if it proves to be that I've got a good option. Might replace the whole ground wire too--it has that black oxidation even where I've cut it back. I wonder if I have the patience to do the whole harness. :) Best, bmc
Sent from my iPhone > On Jul 31, 2015, at 16:07, James Roybal <[email protected]> wrote: > > Check for corrosion on the power cord where it connects to the machine's > on/off switch. Mine is younger than yours and the ends of the wire basically > fell to pieces when I touched them. They were black from overheating and very > brittle, those may be increasing the current the machine uses, tripping the > GFI. I'm going to be replacing the cord with a better quality and larger > gauge wire. > > -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/brewtus. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
