Bill, I’d bet on the gauge itself being the culprit. There shouldn’t be any pressure showing when cold and, since it does move when the portafilter is pressurized, it doesn’t seem to be a problem with the connections. If so, no need to do anything unless it bothers you. Have you tried tapping it to see what it does when cold?
Jonathan From: [email protected] <[email protected]> On Behalf Of wsmckenz Sent: Saturday, November 2, 2019 11:33 AM To: Brewtus <[email protected]> Subject: Brew Boiler Pressure Meter Meter sits at 6 or 7 bar all the time, even unplugged and stone cold. Still goes to 9 or 10 while pulling a shot, and I can dial that value up and down with the pressure setting off the pump. But what is wrong? Is the zero setting just bad? I see a couple of brass triangle shaped adjustment screws on the dial itself, but it doesnt look very easy to get at them. When I open to the pre-infusion level, it drops a bit, but then pulls back up. Is this worth worrying about? ~Bill -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected] <mailto:[email protected]> . To view this discussion on the web visit https://groups.google.com/d/msgid/brewtus/97e2ed65-d589-4a68-91c6-bc051179130a%40googlegroups.com <https://groups.google.com/d/msgid/brewtus/97e2ed65-d589-4a68-91c6-bc051179130a%40googlegroups.com?utm_medium=email&utm_source=footer> . -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/brewtus/00b301d591b1%24ebb58b40%24c320a1c0%24%40gmail.com.
