I was replacing the temperature probe on my B-II today because I was getting impossible temperature fluctuations after the machine was at temp for a while. it would quickly dip down to 70c and then back up to 95c within 30 seconds or so. While loosening the contacts on the AKO controller i guess I held on with too much force (and it was not very much), the entire case basically shattered because it was so brittle. it won't seat back in the housing now and it cracked in so many places like egg shell. Anyone have thoughts on whether to buy a new AKO controller, upgrade to PID or just thank this machine for 15 years of service and buy something new?
Two years ago I replaced the Gicar control board (bad relay), pump, pressurestat and OPV and everything was going great except the temperature fluctuation. Thanks -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/brewtus/cb810840-04ef-4c5a-98f2-c8db667005d2n%40googlegroups.com.
