Hello,
In one of our project we need to connect one IMX 27 based baord which ahs a
internal FEC controller & an MPC 8323RDb baord which has a Built in Network
controller.
We need to connect the IMX27 based board to MPC board thro cross cable & MPC
baord has wlan AP card .
Basically we want to communicate from IMX27 to wireless network. Hence we are
planning to make follwoing arranage ment as given in the attached ppt & we use
bridge as per this site
http://www.linuxfoundation.org/en/Net:Bridge
If we use external network controller we can acheive teh communication as
desired by bridging ra0 ( wlan ) & eth0 on MPC baord . BUt if we use IMX27
internal FEC controller we are unable to acheive the communication by bridging
the eth0 & ra0 on MPC baord.
Anything setting to be done on the IMX 27 board? ( kernel configs, or specofoc
protocol related configs?)
If we don't do teh bridging on the MPC side, we can communicate directly from
IMX27 to MPC thor cross connection ( without bridging)
Can we get some inputs? has anybody tried similarly earlier ?
Regards
Praveen
_______________________________________________
Bridge mailing list
[email protected]
https://lists.linux-foundation.org/mailman/listinfo/bridge
