Hi,
I use the bridge these days but I come up with some problems when I use
it.
I add two wifi interfaces to the bridge I call it "br0" . What I do is
as follows :
#brctl addbr br0
#brctl addif br0 eth0
#brctl addif br0 eth1
#ifconfig eth0 0.0.0.0
#ifconfig eth1 0.0.0.0
#ifconfig br0 up
#dhclient br0
The AP gives br0 the address 172.31.24.68 and the gateway is 172.31.24.1
(this detailed address maybe not important though)
I use the command ifconfig and find that the br0's mac is the same as
eth1's . When both the two wifi interfaces are up ,there's no problem when PING
the gateway . But when I ifconfig eth1 down , PING the gateway again ,it shows
destination host unreachable . But when I ifconfig eth0 down , it doesn't
affect PING the gateway . I think this may because br0 is bound to eth1 , the
traffic pass through eth1 .
Now here comes the problem . I want br0 bound to eth0 ,what should I do ?
I'm looking forward to your answer and I'm eager to know it. Thank you
very much ._______________________________________________
Bridge mailing list
[email protected]
https://lists.linux-foundation.org/mailman/listinfo/bridge
