Hi
I intent to use brctl to bridge two devices on linux box. One is eth0,
the other is USB net which is recognized as usb0 by linux box.
Then I run following command
# ifconfig eth0 down
# ifconfig usb0 down
# brctt addbr ipbr
# brctl addif ipbr eth0
# brctl addif ipbr usb0
# ifconfig eth0 up
# ifconfig eth0 0.0.0.0
# ifconfig usb0 up
# ifconfig usb0 0.0.0.0
# ifconfig ipv6 up
eth0 usb0
192.168.16.2
Box1<----------------> Linux bridge <----------------------> Box
Then I connet another device into the eth0 interface of bridge. Its ip
address is 192.168.16.1, the device on the othe end of usb lan is
192.168.16.2
When I ping 192.168.16.2 from 192.168.16.1. The tcpdump on bridge is
message of ARP "who has 192.168.16.2 tell 192.168.16.1", but I neve see
the ARP reply why?
Thanks
Best Regards
_______________________________________________
Bridge mailing list
[email protected]
https://lists.osdl.org/mailman/listinfo/bridge
