Hi!
I switched STP off, but the ports still don't go diretly to forwarding
state. What's the matter?
NETDEV WATCHDOG: eth1: transmit timed out
eth1: Tx timed out, cable problem? TSR=0x0, ISR=0x0, t=40.
--- Right, cable disconnected
br0: port 2(eth1) entering disabled state
--- I did "ip link set eth1 down"
--- and later "ip link set eth1 up"
br0: port 2(eth1) entering listening state
br0: port 2(eth1) entering learning state
br0: port 2(eth1) entering forwarding state
br0: topology change detected, propagating
--- This takes a minute...
NETDEV WATCHDOG: eth1: transmit timed out
eth1: Tx timed out, cable problem? TSR=0x0, ISR=0x0, t=31.
--- Now the bridge is forwarding
--- ...still no cable there, but this stays the same the other way...
Everthing would be fine, but
[root@panorama root]# brctl show
bridge name bridge id STP enabled interfaces
br0 8000.00201880e21d no eth0
eth1
shows, that I switched STP off!
As the "brctl" tool has no "--version" switch, I cant tell you what I
have... (-:
Any ideas??
Regards,
Robert
_______________________________________________
Bridge mailing list
[EMAIL PROTECTED]
http://www.math.leidenuniv.nl/mailman/listinfo/bridge
