What is the output of ip addr show
Shaiful wrote: > Hi, > > I'm trying to set up a bridging firewall under linux > Red Hat 7.3 using two network cards, 3com 3c59x and > eepro100. Unfortunately, every time I restarted the > network service, the routing table info using 'route' > is always as follows: > > Kernel IP routing table > Destination Gw Genmask Flags Metric Ref Use If > 192.168.0.0 * 255.255.255.0 U 0 0 0 eth1 > 192.168.0.0 * 255.255.255.0 U 0 0 0 eth1 > 127.0.0.0 * 255.0.0.0 U 0 0 0 lo > default 192.168.0.1 0.0.0.0 UG 0 0 0 eth0 > > The two bottom lines are OK, but the top two are wrong > and redundant. I can always change/delete the top two > configuration using 'route' command but it is not > permanent. I don't like using rc.local either.. > > I've tried to change the configuration under > /etc/sysconfig/static-routes > but fruitless. > > Can somebody please tell where is the configuration > file for editing the top two routing statements? Or I > might use Slackware instead ;-) > > Thanks in advance, > > Regards, > Shaiful > > __________________________________________________ > Do You Yahoo!? > LAUNCH - Your Yahoo! Music Experience > http://launch.yahoo.com > _______________________________________________ > Bridge mailing list > [EMAIL PROTECTED] > http://www.math.leidenuniv.nl/mailman/listinfo/bridge _______________________________________________ Bridge mailing list [EMAIL PROTECTED] http://www.math.leidenuniv.nl/mailman/listinfo/bridge
