I'm not certain just how you've set this up, but it sounds a little funny. Here's a couple hints off the cuff. Does eth0 have an IP address? It shouldn't, since it's part of the bridge interface. Does br0 have and IP address? It should, if you want to redirect traffic to it. To do transparent proxying, you need an address to which squid can bind. Maybe a little asci art? Everyone loves art...
Jeremy Jeremy Jones Department of Juvenile Corrections IT Systems Integration Analyst, Senior (208) 465-8443 mailto:[EMAIL PROTECTED] >>> "Network Administrator" <[EMAIL PROTECTED]> 01/16/03 09:52 AM >>> I couldn't find a clear answer to this one in the list.... I am attempting to create a transparent squid proxy. I have the bridge all setup, iptables works fine. The problem I have run into is that when I try to redirect port 80 to port 3128 nothing ever comes back to me. Here is my setup: eth0--------eth1 ( this is the bridge "br0" ) eth2 (public ip address for squid to use) I am connected to eth0, eth1 & eth2 go to the LAN. I tried the following iptables rules, which I got from "Transparent Proxy with Linux and Squid mini-HOWTO" iptables -t nat -A PREROUTING -i eth0 -p tcp --dport 80 -j REDIRECT --to-port 3128 iptables -A INPUT -i eth0 -p tcp --dport 3128 -m state --state NEW,ESTABLISHED -j ACCEPT Any Ideas? Thanks, Brett Carroll Network Administrator WireFire Internet Service [EMAIL PROTECTED] _______________________________________________ Bridge mailing list [EMAIL PROTECTED] http://www.math.leidenuniv.nl/mailman/listinfo/bridge _______________________________________________ Bridge mailing list [EMAIL PROTECTED] http://www.math.leidenuniv.nl/mailman/listinfo/bridge
