so sorry mailing again.
I would like to set standby switch like this.
So if a main switch is down, I would like to service with standby switch instead of main switch.
(traffic using only main switch and just connects with standby switch at normal state)
and I connected main switch with eth0, Sub switch with eth1,
and additionally connects standby switch with eth2 at the bridge firewall.
Main Switch Standby Switch |(eth0) |(eth2)
| |
---------------------------
|
Bridge Firewall
|
Sub Switch (eth1)
Then, How can I change this brctl script?
(HSRP between Main Switch and Standby Switch)
### pre configuration just using eth0 and eth1 brctl addbr br0 brctl stp br0 off brctl addif br0 eth0 brctl addif br0 eth1 ifconfig eth0 down ifconfig eth1 down ifconfig eth0 0.0.0.0 promisc up ifconfig eth1 0.0.0.0 promisc up ifconfig br0 211.1.1.1 promisc up route add default gw 211.1.1.1
should do I change like this to us standby switch? Will it works well? doesn't do loop?
## modified configuration using eth0, eth1 and eth2. is it works well or not?
brctl addbr br0 brctl stp br0 off brctl addif br0 eth0 brctl addif br0 eth1 brctl addif br0 eth2 ifconfig eth0 down ifconfig eth1 down ifconfig eth2 down ifconfig eth0 0.0.0.0 promisc up ifconfig eth1 0.0.0.0 promisc up ifconfig eth2 0.0.0.0 promisc up ifconfig br0 211.1.1.1 promisc up route add default gw 211.1.1.1
and should I do "stp on" or "stp off"?
So sorry my poor english.
Thanks in advance.
_________________________________________________________________
_______________________________________________ Bridge mailing list [EMAIL PROTECTED] http://www.math.leidenuniv.nl/mailman/listinfo/bridge
