Revision: 77534
http://sourceforge.net/p/brlcad/code/77534
Author: brlcad
Date: 2020-10-22 04:34:28 +0000 (Thu, 22 Oct 2020)
Log Message:
-----------
switch the nirt binding from 'n' to 'S' for shoot or sample. need to review
all bindings, but this adds some safety to the invocation. switching the key
binding to requiring a modifier (i.e., shift-s) makes it less likely to be
accidentally triggered which is important given neither mged or archer handle
nirt's invocation gracefully / asynchronously. encountered a hard multi-minute
unresponsive lockup while spinning a nurbs model around as nirt ran prep.
Modified Paths:
--------------
brlcad/trunk/src/tclscripts/mged/bindings.tcl
Modified: brlcad/trunk/src/tclscripts/mged/bindings.tcl
===================================================================
--- brlcad/trunk/src/tclscripts/mged/bindings.tcl 2020-10-22 04:26:45 UTC
(rev 77533)
+++ brlcad/trunk/src/tclscripts/mged/bindings.tcl 2020-10-22 04:34:28 UTC
(rev 77534)
@@ -122,10 +122,10 @@
bind $w t "winset $w; press top; break"
bind $w b "winset $w; press bottom; break"
bind $w l "winset $w; press left; break"
- bind $w n "winset $w; puts \[nirt -b\]; break"
bind $w r "winset $w; press right; break"
bind $w R "winset $w; press rear; break"
bind $w s "winset $w; press sill; break"
+ bind $w S "winset $w; puts \[nirt -b\]; break"
bind $w o "winset $w; press oill; break"
bind $w q "winset $w; press reject; break"
bind $w A "winset $w; press accept; break"
This was sent by the SourceForge.net collaborative development platform, the
world's largest Open Source development site.
_______________________________________________
BRL-CAD Source Commits mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/brlcad-commits
