Revision: 78003
http://sourceforge.net/p/brlcad/code/78003
Author: starseeker
Date: 2020-12-18 17:15:37 +0000 (Fri, 18 Dec 2020)
Log Message:
-----------
Adjust path, define in one location
Modified Paths:
--------------
brlcad/trunk/src/gtools/tests/CMakeLists.txt
Modified: brlcad/trunk/src/gtools/tests/CMakeLists.txt
===================================================================
--- brlcad/trunk/src/gtools/tests/CMakeLists.txt 2020-12-18 17:11:52 UTC
(rev 78002)
+++ brlcad/trunk/src/gtools/tests/CMakeLists.txt 2020-12-18 17:15:37 UTC
(rev 78003)
@@ -10,14 +10,16 @@
# Test GQA's ability to write out valid plot files, both in single and
# multithreaded modes.
+set(GQA_GFILE "${CMAKE_CURRENT_SOURCE_DIR}/../../libged/tests/ged_tests.g")
+
set(GQA_PFILE "${CMAKE_CURRENT_BINARY_DIR}/ovlp_overlaps.plot3")
-BRLCAD_ADD_TEST(NAME gqa_plot COMMAND gqa -P 1 -Ao -p ovlp_
"${CMAKE_CURRENT_SOURCE_DIR}/../libged/tests/ged_tests.g" ovlp)
+BRLCAD_ADD_TEST(NAME gqa_plot COMMAND gqa -P 1 -Ao -p ovlp_ "${GQA_GFILE}"
ovlp)
BRLCAD_ADD_TEST(NAME gqa_plot_verify COMMAND bn_plot3 -b "${GQA_PFILE}")
set_property(TEST gqa_plot_verify PROPERTY DEPENDS gqa_plot)
DISTCLEAN("${GQA_PFILE}")
set(GQA_MULTI_PFILE "${CMAKE_CURRENT_BINARY_DIR}/ovlpmulti_overlaps.plot3")
-BRLCAD_ADD_TEST(NAME gqa_plot_multithreaded COMMAND gqa -Ao -p ovlpmulti_
"${CMAKE_CURRENT_SOURCE_DIR}/../libged/tests/ged_tests.g" ovlp)
+BRLCAD_ADD_TEST(NAME gqa_plot_multithreaded COMMAND gqa -Ao -p ovlpmulti_
"${GQA_GFILE}" ovlp)
BRLCAD_ADD_TEST(NAME gqa_plot_verify_multithreaded COMMAND bn_plot3 -b
"${GQA_MULTI_PFILE}")
set_property(TEST gqa_plot_verify_multithreaded PROPERTY DEPENDS
gqa_plot_multithreaded)
DISTCLEAN("${GQA_MULTI_PFILE}")
This was sent by the SourceForge.net collaborative development platform, the
world's largest Open Source development site.
_______________________________________________
BRL-CAD Source Commits mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/brlcad-commits
