Revision: 78033
http://sourceforge.net/p/brlcad/code/78033
Author: starseeker
Date: 2020-12-19 23:07:32 +0000 (Sat, 19 Dec 2020)
Log Message:
-----------
Merge from trunk r78029 through r78031
Modified Paths:
--------------
brlcad/branches/extbuild/regress/mged/mged.sh
Property Changed:
----------------
brlcad/branches/extbuild/
brlcad/branches/extbuild/regress/
Index: brlcad/branches/extbuild
===================================================================
--- brlcad/branches/extbuild 2020-12-19 23:07:11 UTC (rev 78032)
+++ brlcad/branches/extbuild 2020-12-19 23:07:32 UTC (rev 78033)
Property changes on: brlcad/branches/extbuild
___________________________________________________________________
Modified: svn:mergeinfo
## -11,4 +11,4 ##
/brlcad/branches/osg:62110-62113
/brlcad/branches/prep-cache:68236-68933
/brlcad/branches/tcltk86:68300-75257
-/brlcad/trunk:77547-78028
\ No newline at end of property
+/brlcad/trunk:77547-78031
\ No newline at end of property
Index: brlcad/branches/extbuild/regress
===================================================================
--- brlcad/branches/extbuild/regress 2020-12-19 23:07:11 UTC (rev 78032)
+++ brlcad/branches/extbuild/regress 2020-12-19 23:07:32 UTC (rev 78033)
Property changes on: brlcad/branches/extbuild/regress
___________________________________________________________________
Modified: svn:mergeinfo
## -10,4 +10,4 ##
/brlcad/branches/osg/regress:62110-62113
/brlcad/branches/prep-cache/regress:68236-68933
/brlcad/branches/tcltk86/regress:68300-75257
-/brlcad/trunk/regress:77700-77770
\ No newline at end of property
+/brlcad/trunk/regress:77700-77770,78029-78031
\ No newline at end of property
Modified: brlcad/branches/extbuild/regress/mged/mged.sh
===================================================================
--- brlcad/branches/extbuild/regress/mged/mged.sh 2020-12-19 23:07:11 UTC
(rev 78032)
+++ brlcad/branches/extbuild/regress/mged/mged.sh 2020-12-19 23:07:32 UTC
(rev 78033)
@@ -99,14 +99,6 @@
return 0
}
-touch mged.g
-output="`$MGED -c mged.g quit 2>&1`"
-if test $? != 0 ; then
- log "Output: $output"
- log "Unable to run mged, aborting"
- exit 1
-fi
-
log "seting up an almost empty database (mged.g) to make sure mged runs"
rm -f mged.g
$MGED -c >> $LOGFILE 2>&1 <<EOF
This was sent by the SourceForge.net collaborative development platform, the
world's largest Open Source development site.
_______________________________________________
BRL-CAD Source Commits mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/brlcad-commits
