My mistake, I mixed up the names, inserting Dave when it should have been Chevelle. I apologize again.
On Fri, Oct 25, 2019, 1:18 AM Oriana Neulinger <[email protected]> wrote: > Hello Dave, > > I never received your reply to this post in my email, so i apologise for > the late response. > > How long should we allow the debugging program to run? Is it possible that > there is no log generated if it gets stuck in a loop while searching for a > USB device? > > Given that the debugging program runs, and the regular program does not, > can the debugging program be used on a longterm basis instead of the > regular program? > > Thank you. > > On Mon, Oct 7, 2019, 6:51 PM Oriana Neulinger <[email protected]> > wrote: > >> Sorry if this creates a new thread, i couldn't figure out how to reply to >> a thread presented in "digest mode". >> >> Further experiments: >> >> 1) On 6.0, running the app "brltty in debug mode" caused a command prompt >> to open and run, but we were unable to set any choices, it got stuck in a >> loop in not finding a usb device (pebkac issue, later solved), but we were >> unable to find the log afterward. Still, if we can hack this bat, it might >> provide some kind of solution, since the program was at least found. >> >> 2) Downloaded and installed 5.6. There is still no app to run BRLTTY in >> the apps menu, and the command prompt still doesn't recognize the command. >> After successfully completing the setup of the alva's new serial-to-usb >> converter (whoops) and correctly setting the configurator app we tried the >> debugging app again and after the command prompt displayed a whole lot of... >> >> serial: output: (hex) >> output packet: sent: (hex) >> >> ...the alva changed it's display from the alva boot-up message to the >> letter "t" regardless of active window and cursor position. >> >> Hey, a mote of success. >> >> We still couldn't find the log file though. >> >> 3) conclusion: Unless the debugging application is a totally different >> binary, i think i might be able to walk her through creating a script to >> put in her startup menu, but now it seems we have a new problem *sweatdrop* >> >
_______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://brltty.app/mailman/listinfo/brltty
