I've been on this list for a long time, and the GNU screen-based
interface to BRLTTY is rarely mentioned. You may be the first person to
try it in quite a while.
On 29/5/21 9:02 pm, Ben van Poppel wrote:
Hi Mario.
Sorry. To put it another way, the only way to successfully run configure is by
setting CC=/usr/local/bin/gcc-11. The only way to build the resulting
configuration is setting it back to clang. No I’m definitely not running the
stock Mac screen binary by mistake, because in testing I included the full
path. By “runs fine“ I mean the resulting screen binary runs and seems
otherwise to perform normally.
cheers.
Ben
On 30 May 2021, at 12:45 am, Mario Lang <[email protected]> wrote:
Ben van Poppel <[email protected]> writes:
The only strangeness when building Screen itself is that configure
fails with Clang and the build fails with duplicate symbols with
standard GCC. But it seems to build and run fine.
This part of the story is confusing to me. You seem to indicate that
building screen fails with clang and gcc. But a sentence later you say
everything is fine. Could you be a little bit more precise?
How (with which compiler) did you actually successfully build screen?
Are you sure it did actually build and install,
and you aren't using a screen binary already installed on your Mac for some
reason?
--
AR Mario Lang Phone: +43 316 873 6897
Graz University of Technology Mobile: +43 664 60 873 6897
IT-Services for research and teaching Email: [email protected]
Steyrergasse 30/1, 8010 Graz, Austria Please https://useplaintext.email/
_______________________________________________
This message was sent via the BRLTTY mailing list.
To post a message, send an e-mail to: [email protected]
For general information, go to: http://brltty.app/mailman/listinfo/brltty
_______________________________________________
This message was sent via the BRLTTY mailing list.
To post a message, send an e-mail to: [email protected]
For general information, go to: http://brltty.app/mailman/listinfo/brltty
