On another topic....
I have been using an APEX BrailleNote BT32 semi-successfully for a while now.
The main gripe I have is that I have to enter space-4-5 after control is taken
with BrlAPI before it will send any perkins input.
This is annoying but marginally acceptable.
What is not quite acceptable (because a blind user will not immediately
recognize what is happening, and because this application is for student
assessment and a user should not be expected to continuously monitor the
behavior of their device during a timed test) is that after a few keystrokes
input I often have type space-4-5 *again* to maintain the perkins keyboard
input state.
Is there a more permanent way to set the input state on this device? Even
better, is there a way to programmatically set the input state so the user does
not have to enter space-4-5 at all?
-Nick
_______________________________________________
This message was sent via the BRLTTY mailing list.
To post a message, send an e-mail to: [email protected]
For general information, go to: http://mielke.cc/mailman/listinfo/brltty
