Dave Mielke <[email protected]> wrote:
> [quoted lines by [email protected] on 2013/05/01 at 01:51 -0400]
>
> Okay, I'm going to assume that the one which ends in fp is the feature pack
> and
> that the one which doesn't end in fp is the braille display.
>
> >When I do the one without I get the following:
> >May 1 01:35:51 ccs brltty[8526]: BRLTTY 4.5 rev Unversioned directory
> >[http://mielke.cc/brltty/]
>
> I guess you used "svn export". If you use "svn checkout" then it should show
> the actual revision number.
I did just a download of the .tar file.
>
> >May 1 01:36:01 ccs brltty[8527]: RFCOMM connect error 16: Device or
> >resource busy.
> >May 1 01:36:16 ccs last message repeated 52 times
>
> Is it possible that some other process is already connected to the device?
> For
> example, you were testing earlier with bluez-test. Might that connection
> still
> 1be up, or, perhaps, might you have another brltty running? Did you enter the
> device's address into any data file(s)? Did you do any testing with the
> rfcomm
> command?
I just paired it and trusted the pairing. I was told to do a connect,
which it said I had to do once only, but I was never successful at doing
that. I have not used the rfcomm command. I did enter the address into
a file for the pin code and the system knew enough to pair the device.
So should I use the one for the Braille display or the featurepack? I
would assume the Braille display, if I read the manual correctly.
--
Your life is like a penny. You're going to lose it. The question is:
How do
you spend it?
John Covici
[email protected]
_______________________________________________
This message was sent via the BRLTTY mailing list.
To post a message, send an e-mail to: [email protected]
For general information, go to: http://mielke.cc/mailman/listinfo/brltty
