10 jun 2013 kl. 15:14 skrev Adrian P. van Bloois <[email protected]>:
> On Mon, Jun 10, 2013 at 02:40:47PM +0200, Anders Holmberg wrote: >> Hi! >> I know that you can put the braille table in the brltty.conf file. >> However can you put an instruction in the startup init script so brltty >> starts with for example the german or the swedish table. > Yes, with the -t YOURCHOICEOFTABLE you can do it. > And where should the -t parameter be in the init script? Should it be in the /etc/init.d/brltty script or where? Where can i read more about this so i wont clutter up the list? /A >> /A >> _______________________________________________ >> This message was sent via the BRLTTY mailing list. >> To post a message, send an e-mail to: [email protected] >> For general information, go to: http://mielke.cc/mailman/listinfo/brltty > > -- > Adri P. van Bloois > Antonlaan 104 email: [email protected] > 3701 VG Zeist voice: +31-(0)-30-6912741 > The Netherlands fax: NONE > > 52 05'15.77"N 5 4'44.56"E > QTH-locater JO 22 OC > > The whole point of cooking is to get as much flavour out of the > ingredients as possible. > -- Delia Smith > > _______________________________________________ > This message was sent via the BRLTTY mailing list. > To post a message, send an e-mail to: [email protected] > For general information, go to: http://mielke.cc/mailman/listinfo/brltty _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty
