Sorry, it was llvm-3.2 (double l) that is no longer supported in mavericks and above. The ports that depend on it are:
-ld64 @136_2+llvm32 cctools @839_2+llvm32 -- Cheryl May the words of my mouth and the meditation of my heart be acceptable to You, Lord, my rock and my Redeemer. (Psalm 19:14 HCSB) On Oct 25, 2013, at 12:41 PM, Cheryl Homiak <[email protected]> wrote: > 1. Screen now also brings up a different version of screen but I still have > screen-4.0.1 on my computer and this works. Just don't expect to type > "screen" and then run brltty until/unless you change screen-4.0.1 to be the > screen version that comes up when you type "screen". > > 2. I found that by typing the path to brltty on my external drive, I could > run brltty on mavericks rather than having to boot into my Mountain Lion > installation. So i copied the executables from /bin on my external drive to > /bin on my hd and that works. So I can run it on mavericks; just can't > compile it there. > > 3. Running "sudo port upgrade outdated" in mavericks yielded > > extracting gperf: error: org.macports.extract for gperf returned command > execution failed > > It turned out that /usr/bin/gnutar is missing from Maverics (yes, this would > indeed make extraction difficult!) and the solution was supposed to be to > reinstall macports from source since there isn't a binary installer yet. > Instead, I copied gnutar from my mountain lion install and it worked, at > least for now. I then proceeded with the port upgrades until a couple (calc, > catdoc) would not install so I just uninstalled them. But then lvm-3.2 was > reported as not being supported in mavericks and higher and there didn't seem > to be any way of getting past that. So that's as far as i got with upgrading > macports. > > 3. Both before and after upgrading what I could in macports, Attempting to > compile brltty after running > sudo svn up > sudo ./autogen > sudo ./configure --disable-iconv (or sudo ./cfg-darwin) > sudo make install yields: > ld: library not found for -lIOKit > clang: error linker command failed with exit code 1 (use -v to see invocation) > make [1]: *** [tbl2hex] Error 1 > make: *** [install] Error 2 > > So, until I get past this, I can run brltty but can't compile it on > Mavericks. At least at the moment, I can apparently compile on Mountain Lion > on my external drive and then copy the executables to Mavericks. > > > -- > Cheryl > > May the words of my mouth > and the meditation of my heart > be acceptable to You, Lord, > my rock and my Redeemer. > (Psalm 19:14 HCSB) > > >
_______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty
