Sebastian Humenda <[email protected]> writes: > Hello, > > Mario Lang schrieb am 01.03.2014, 17:52 +0100: >>Sebastian Humenda <[email protected]> writes: >> >>> Hi, >>> >>> with the latest source from the git repository, as well as the stable >>> release of >>> BRLTTY, my focus display stops working after a time (from 10 - 60 seconds). >>> When speech is enabled, I notice that BRLTTY is still up and running, but >>> the >>> display stopped working. It can be re-enabled by pressing a key on the >>> display. >>> For debugging, I have created a log file using "-l 7 -n -e", it is attached. >>> Could you please have a look into that? >> >>Please use "-L output.log" instead of redirecting to a file, since that >>will add timestampts to the log entries, which are rather important to >>diagnose such timing related problems. > Thanks, the new log is attached. > My first impression was that the display stops working after I have waited > for a > few seconds, but this log should show the opposite. When I pressed FWINLT, the > display had just stopped working. The key press brought it back.
The offending warning seems to be 2014-03-01@19:29:34.911 Missing ACK; assuming NAK. But the rest of the log entries does not point at why this would have happend. Can you retry with "-l 7,ingio,inpkts,outpkts,async,usb" ? I am assuming you are using USB. If you use bluetooth, replace "usb", with "bluetooth". -- CYa, ⡍⠁⠗⠊⠕ _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty
