[quoted lines by Alastair Irving on 2015/02/25 at 11:31 -0500] >I tried updating to Brltty 5.2 from 5.1, but there seems to be a >problem with the interface to the latex-access executable table. >Specifically, Brltty works fine until I try and switch to contracted >braille using latex-access at which point the Brltty process >immediately dies. I've tried setting the debug level to the highest >but there are no error messages given before the crash.
Can you set "ulimit -c unlimited" before running brltty (must be done from the same shell), and then, using gdb, the executable, and the core file, get a backtrace of where the crash is occurring? >I was wondering if the developers have any idea which change between >5.1 and 5.2 might be causing the problem? No, I don't. Are you able to build the latest development code to see if the problem is still occurring? I found a copy of latex-access on my system, but haven't yet figured out how to get Python to see it. If I can figure that out, then I'll try to do some direct testing. -- Dave Mielke | 2213 Fox Crescent | The Bible is the very Word of God. Phone: 1-613-726-0014 | Ottawa, Ontario | http://Mielke.cc/bible/ EMail: [email protected] | Canada K2A 1H7 | http://FamilyRadio.org/ _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty
