On Sat, Mar 05, 2016 at 09:50:31PM +0100, Anders Holmberg wrote:
> Hi!
> I am lost on the brltty site.
> I try to find the info on how to start brltty using systemd.
> Where can this be found?
I'm using CentOS 7 and I do:
sudo systemctl enable brltty
This is equivalant to:
chkconfig brltty on
And:
sudo systemctl start brltty
This is equivalent to:
service brltty start
You can see if brltty is enabled by typing:
systemctl list-unit-files |grep brltty
Attached is the man page of systemctl which is the crucial command.
Good luck
Adrian
> /A
> _______________________________________________
> This message was sent via the BRLTTY mailing list.
> To post a message, send an e-mail to: [email protected]
> For general information, go to: http://mielke.cc/mailman/listinfo/brltty
--
Adri P. van Bloois
Antonlaan 104 email: [email protected]
3701 VG Zeist voice: +31-(0)-30-6912741
The Netherlands fax: NONE
52 05'15.77"N 5 4'44.56"E
QTH-locater JO 22 OC
"Elegance is not a dispensable luxury but a factor that decides between
success and failure."
Edsger W. Dijkstra
systemctl.man
Description: Unix manual page
_______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty
