14.09.2011, 18:37, "Kurt Miller" <k...@intricatesoftware.com>:
> On Wednesday 14 September 2011 04:24:27 am Konstantin Tokarev wrote:
>
>>  13.09.2011, 19:31, "Kurt Miller" <k...@intricatesoftware.com>:
>>>   On Tuesday 13 September 2011 11:18:15 am Konstantin Tokarev wrote:
>>>>    13.09.2011, 18:02, "Kurt Miller" :
>>>>>    Ideally you could use my fastdebug w/atomic.diff build to generate the 
>>>>> core and make it available to me (compressed). This would allow me to to 
>>>>> do a more complete diagnostic on the crash.
>>>>>
>>>>>    The build is here: 
>>>>> http://www.intricatesoftware.com/OpenJDK/macppc/openjdk7-macppc-fcs-fd-atomic-2011-09-12.tar.bz2
>>>>    Seems like your host is down
>>>>
>>>>    http://www.downforeveryoneorjustme.com/www.intricatesoftware.com
>>>   Thanks. I switched it to my backup ip. It is up again now.
>>>>    I can send my core, though.
>>>   It would be better to generate the core using my build so when I debug it 
>>> here everything matches exactly.
>>  Attached.
>
> Thank you. I downloaded it and checked it out with gdb. Unfortunately gdb 
> can't unwind
> beyond the signal handler so I still can't see where the crash is comming 
> from. :-(

I'm afraid breakpoint with further single-stepping is needed. Could you give a 
hint about reasonable place?

>
> Perhaps the source of the crash can be determined with an active gdb session.
> I'm building a full debug build now which should contain source line numbers. 
> If the
> segfault is caught while gdb is attached having the full debug build will be 
> helpful.
> I'll upload it when the build finishes.

OK, I'll try it. Maybe I'll take an opportunity to upgrade RAM before start 
debugging :)

-- 
Regards,
Konstantin

Reply via email to