I am new to the list but I have worked with BSDRP on some occasions, I am
building a router where I have 6 igb interfaces. I would like to divide it
into 3 interfaces up 3 interfaces down in the case using lacp for
aggregation I made the configurations in rc.conf according below:
ifconfig_igb0 = "up"
ifconfig_igb1 = "up"
ifconfig_igb2 = "up"
cloned_interfaces = "lagg0 lagg1"
ifconfig_lagg0 = "up"
vlans_lagg0 = "1022 1023 623 311"
ifconfig_igb3 = "up"
ifconfig_igb4 = "up"
ifconfig_igb5 = "up"
ifconfig_lagg1 = "up"
vlans_lagg1 = "12 101 3101 3102 3103 3104 3105"
ifconfig_lagg1_101 = "inet 10.0.100.254/23"
if_lagg_load = "YES"
But the LAGG interfaces do not seem to work anyone could help me LAGG
interfaces are shown without mac address address and "no carrier" as below:
lagg0: flags = 8843 <UP, BROADCAST, RUNNING, SIMPLEX, MULTICAST> metric 0
mtu 1500
ether 00: 00: 00: 00: 00 00
inet6 fe80 :: 8644: 64ff: fe35: f5d8% lagg0 prefixlen 64 scopeid 0x9
nd6 options = 21 <PERFORMNUD, AUTO_LINKLOCAL>
media: Ethernet autoselect
status: no carrier
groups: lagg
laggproto failover lagghash l2, l3, l4
lagg1: flags = 8843 <UP, BROADCAST, RUNNING, SIMPLEX, MULTICAST> metric 0
mtu 1500
ether 00: 00: 00: 00: 00 00
inet6 fe80 :: 8644: 64ff: fe35: f5d8% lagg1 prefixlen 64 scopeid 0xa
nd6 options = 21 <PERFORMNUD, AUTO_LINKLOCAL>
media: Ethernet autoselect
status: no carrier
groups: lagg
Also I would like some explanation of how to enable the netmap and apply
good tuning practices if anyone can help I am grateful.
_______________________________________________
Bsdrp-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bsdrp-users
