Hello, I ran the automated setup for the CYGWIN compiler. The install was a success, but now that I am trying to run the debugger, Two things are happening. 1st) the debugger only shows the assembler code even if I select the Source selection. 2nd) when I step through the code and it is at the end of it, the computer freezes up. I am using the NT OS. Can you please tell me what should I do to be able to see the Source code when debugging and also for the computer not to freeze at the end of the code. Thank you for the support. Felix Saldarriaga Computer Engineer II Motorola Retail Products Division 8000 West Sunrise Blvd. Room 1C15 Sunrise, Florida 33313 Phone: (954) 723 - 3120 Pager: (954)723 - 4567 pin 5559 Fax: (954) 723 - 8170 mailto:[EMAIL PROTECTED] _______________________________________________ Bug-gdb mailing list [EMAIL PROTECTED] http://mail.gnu.org/mailman/listinfo/bug-gdb