thanks, I am not a C programmer, so all I can give you is the setup. It might just be that the 3TB drive was not seen correctly as connected to the USB/SATA controller on the following below: HTH regards Linux mercedes 2.6.9-67.0.7.ELsmp #1 SMP Sat Mar 15 06:54:55 EDT 2008 i686 i686 i386 GNU/Linux usb 1-1: new high speed USB device using address 3 Initializing USB Mass Storage driver... scsi2 : SCSI emulation for USB Mass Storage devices Vendor: ST330006 Model: 51AS Rev: Type: Direct-Access ANSI SCSI revision: 02 SCSI device sdc: 1565565872 512-byte hdwr sectors (801570 MB) sdc: assuming drive cache: write through SCSI device sdc: 1565565872 512-byte hdwr sectors (801570 MB) sdc: assuming drive cache: write through sdc: unknown partition table Attached scsi disk sdc at scsi2, channel 0, id 0, lun 0 USB Mass Storage device found at 3 usbcore: registered new driver usb-storage USB Mass Storage support registered. VFS: Can't find ext3 filesystem on dev sdc. On 28/09/2011 2:34 PM, rahul dev wrote:
--
![]() "C9H13N" |
<<attachment: nick.vcf>>
_______________________________________________ bug-parted mailing list bug-parted@gnu.org https://lists.gnu.org/mailman/listinfo/bug-parted