I guess that the kernel can't read the HDD connected to the SATA port.
fsck can't find any sector when I run it using bsd.rd.
U-Boot 2016.05 (Jun 23 2016 - 01:28:15 -0600) Allwinner Technology
CPU: Allwinner A20 (SUN7I)
Model: Olimex A20-OLinuXino-LIME2
I2C: ready
DRAM: 1 GiB
MMC: SUNXI SD/MMC: 0
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
SCSI: Target spinup took 0 ms.
AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl SATA mode
flags: ncq stag pm led clo only pmp pio slum part ccc apst
Net: eth0: ethernet@01c50000
starting USB...
USB0: USB EHCI 1.00
USB1: USB OHCI 1.0
USB2: USB EHCI 1.00
USB3: USB OHCI 1.0
scanning bus 0 for devices... 1 USB Device(s) found
scanning bus 2 for devices... 2 USB Device(s) found
Hit any key to stop autoboot: 2 0
=> run bootcmd_scsi0
scanning bus for devices...
Device 0: (0:0) Vendor: ATA Prod.: HTS721010G9SA00 Rev: MCZI
Type: Hard Disk
Capacity: 95396.2 MB = 93.1 GB (195371568 x 512)
Found 1 device(s).
SCSI device 0:
Device 0: (0:0) Vendor: ATA Prod.: HTS721010G9SA00 Rev: MCZI
Type: Hard Disk
Capacity: 95396.2 MB = 93.1 GB (195371568 x 512)
... is now current device
Scanning scsi 0:1...
reading /sun7i-a20-olinuxino-lime2.dtb
29895 bytes read in 8 ms (3.6 MiB/s)
Found EFI removable media binary efi/boot/bootarm.efi
reading efi/boot/bootarm.efi
65196 bytes read in 10 ms (6.2 MiB/s)
## Starting EFI application at 0x42000000 ...
Scanning disks on scsi...
Scanning disks on usb...
Scanning disks on mmc...
MMC Device 1 not found
MMC Device 2 not found
MMC Device 3 not found
Found 2 disks
>> OpenBSD/armv7 BOOTARM 0.1
|/-\|boot>
/-\|/-\booting sd0a:/bsd:
|/-\|3744048/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/+139412-\|/-\|/-+479308
[64+501840\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/+238350-\|/-\|/-\|/-\]=0x4e3df4
OpenBSD/armv7 booting ...
arg0 0x40000000 arg1 0x10bb arg2 0x48000000
Allocating page tables
freestart = 0x407e4000, free_pages = 260124 (0x0003f81c)
IRQ stack: p0x40812000 v0xc0812000
ABT stack: p0x40813000 v0xc0813000
UND stack: p0x40814000 v0xc0814000
SVC stack: p0x40815000 v0xc0815000
Creating L1 page table at 0x407e4000
Mapping kernel
Constructing L2 page tables
undefined page pmap [ using 740628 bytes of bsd ELF symbol table ]
board type: 4283
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2016 OpenBSD. All rights reserved. http://www.OpenBSD.org
OpenBSD 6.0-current (GENERIC) #20: Mon Aug 15 19:03:19 MDT 2016
[email protected]:/usr/src/sys/arch/armv7/compile/GENERIC
real mem = 1073741824 (1024MB)
avail mem = 1044480000 (996MB)
mainbus0 at root: Olimex A20-OLinuXino-LIME2
cpu0 at mainbus0: ARM Cortex A7 rev 4 (ARMv7 core)
cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled
cpu0: 32KB(32b/l,2way) I-cache, 32KB(64b/l,4way) wr-back D-cache
cortex0 at mainbus0
sunxi0 at mainbus0
sxipio0 at sunxi0: 175 pins
sxiccmu0 at sunxi0
gpio0 at sxipio0: 18 pins
gpio1 at sxipio0: 24 pins
gpio2 at sxipio0: 25 pins
gpio3 at sxipio0: 28 pins
gpio4 at sxipio0: 12 pins
gpio5 at sxipio0: 6 pins
gpio6 at sxipio0: 12 pins
gpio7 at sxipio0: 28 pins
gpio8 at sxipio0: 22 pins
agtimer0 at mainbus0: tick rate 24000 KHz
simplebus0 at mainbus0: "soc"
ehci0 at simplebus0
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "Allwinner EHCI root hub" rev 2.00/1.00 addr 1
sxiahci0 at simplebus0: AHCI 1.1
sxiahci0: port 0: 1.5Gb/s
scsibus0 at sxiahci0: 32 targets
sd0 at scsibus0 targ 0 lun 0: <ATA, HTS721010G9SA00, MCZI> SCSI3 0/direct fixed
t10.ATA_HTS721010G9SA00_MPCZN7Y0J9XTDL
sd0: 95396MB, 512 bytes/sector, 195371568 sectors
ehci1 at simplebus0
usb1 at ehci1: USB revision 2.0
uhub1 at usb1 "Allwinner EHCI root hub" rev 2.00/1.00 addr 1
sxidog0 at simplebus0
sxirtc0 at simplebus0
sxiuart0 at simplebus0: console
dwge0 at simplebus0
dwge0: Ethernet address: 02:0f:02:42:01:20
rgephy0 at dwge0 phy 1: RTL8169S/8110S/8211 PHY, rev. 2
ampintc0 at simplebus0 nirq 160
run0 at uhub1 port 1 configuration 1 interface 0 "Ralink 802.11 n WLAN" rev
2.00/1.01 addr 2
run0: MAC/BBP RT5390 (rev 0x0502), RF RT5370 (MIMO 1T1R), address
7c:dd:90:02:47:50
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
boot device: sd0
root on sd0a (5e1e16eae3186591.a) swap on sd0b dump on sd0b
exec /sbin/init: error 8
init: not found
panic: no init
Stopped at $d: ldrb r15, [r15, r15, ror r15]!
TID PID UID PRFLAGS PFLAGS CPU COMMAND
* 1 1 0 0 0 0 swapper
panic+0x18
scp=0xc03c64e8 rlv=0xc0399908 (start_init+0x210)
rsp=0xcc3bbf48 rfp=0xcc3bbfac
start_init+0x10
scp=0xc0399708 rlv=0xc05331d0 (proc_trampoline+0x18)
rsp=0xcc3bbfb0 rfp=0xc0816f54
r10=0xc06fe60c r9=0x00000000 r8=0xc06fe7b8 r7=0x00000000
r6=0x00000000 r5=0xca4a2000 r4=0xc03996f8
Bad frame pointer: 0xc0816f54
http://www.openbsd.org/ddb.html describes the minimum info required in bug
reports. Insufficient info makes it difficult to find and fix bugs.
ddb> trace
panic+0x18
scp=0xc03c64e8 rlv=0xc0399908 (start_init+0x210)
rsp=0xcc3bbf48 rfp=0xcc3bbfac
start_init+0x10
scp=0xc0399708 rlv=0xc05331d0 (proc_trampoline+0x18)
rsp=0xcc3bbfb0 rfp=0xc0816f54
r10=0xc06fe60c r9=0x00000000 r8=0xc06fe7b8 r7=0x00000000
r6=0x00000000 r5=0xca4a2000 r4=0xc03996f8
Bad frame pointer: 0xc0816f54
ddb> ps
TID PPID PGRP UID S FLAGS WAIT COMMAND
51595 0 0 0 3 0x14200 pgzero zerothread
72043 0 0 0 3 0x14200 aiodoned aiodoned
1863 0 0 0 3 0x14200 syncer update
84365 0 0 0 3 0x14200 cleaner cleaner
78275 0 0 0 3 0x14200 reaper reaper
80532 0 0 0 3 0x14200 pgdaemon pagedaemon
43762 0 0 0 3 0x14200 bored crynlk
23050 0 0 0 3 0x14200 bored crypto
86258 0 0 0 3 0x14200 pftm pfpurge
48084 0 0 0 3 0x14200 usbtsk usbtask
3509 0 0 0 3 0x14200 usbatsk usbatsk
30447 0 0 0 3 0x14200 bored softnet
60192 0 0 0 3 0x14200 bored systqmp
98796 0 0 0 3 0x14200 bored systq
56322 0 0 0 3 0x40014200 idle0
71450 0 0 0 3 0x14200 kmalloc kmthread
* 1 0 0 0 7 0 swapper
0 -1 0 0 3 0x10200 scheduler swapper
ddb> show uvm
Current UVM status:
pagesize=4096 (0x1000), pagemask=0xfff, pageshift=12
255079 VM pages: 1 active, 0 inactive, 0 wired, 254128 free (31775 zero)
min 10% (25) anon, 10% (25) vnode, 5% (12) vtext
pages 0 anon, 0 vnode, 0 vtext
freemin=8502, free-target=11336, inactive-target=0, wired-max=85026
faults=1, traps=53, intrs=0, ctxswitch=802 fpuswitch=0
softint=480, syscalls=0, kmapent=23
fault counts:
noram=0, noanon=0, noamap=0, pgwait=0, pgrele=0
ok relocks(total)=0(0), anget(retries)=0(0), amapcopy=0
neighbor anon/obj pg=0/0, gets(lock/unlock)=0/0
cases: anon=0, anoncow=0, obj=0, prcopy=0, przero=1
daemon and swap counts:
woke=0, revs=0, scans=0, obscans=0, anscans=0
busy=0, freed=0, reactivate=0, deactivate=0
pageouts=0, pending=0, nswget=0
nswapdev=0, nanon=0, nanonneeded=0 nfreeanon=0
swpages=0, swpginuse=0, swpgonly=0 paging=0
kernel pointers:
objs(kern)=0xc06dda1c
ddb> show bcstats
Current Buffer Cache status:
numbufs 16 busymapped 0, delwri 0
kvaslots 409 avail kva slots 409
bufpages 61, dirtypages 0
pendingreads 0, pendingwrites 0
ddb>
Current Buffer Cache status:
numbufs 16 busymapped 0, delwri 0
kvaslots 409 avail kva slots 409
bufpages 61, dirtypages 0
pendingreads 0, pendingwrites 0
ddb>
--
Juan Francisco Cantero Hurtado http://juanfra.info
