Hi, i get this trying to use usb tethering w/android on edgerouter lite latest(or very close) snap GENERIC.MP: urndis0 at uhub1 port 1 configuration 1 interface 0 "SAMSUNG SAMSUNG_Android" rev 2.00/ff.ff addr 4 urndis0: using RNDISurndis0: IOERROR urndis0: unable to get query response : unable to get hardware address
missing letoh32() somewhere in init path? full dmesg from where i tried to enable the urndis twice below. -Artturi Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. Copyright (c) 1995-2017 OpenBSD. All rights reserved. https://www.OpenBSD.org OpenBSD 6.1-current (GENERIC.MP) #0: Tue Aug 1 05:17:56 UTC 2017 visa@octeon:/usr/src/sys/arch/octeon/compile/GENERIC.MP real mem = 536870912 (512MB) avail mem = 524009472 (499MB) mainbus0 at root cpu0 at mainbus0: CN50xx CPU rev 0.1 500 MHz, Software FP emulation cpu0: cache L1-I 32KB 4 way D 8KB 64 way, L2 128KB 8 way cpu1 at mainbus0: CN50xx CPU rev 0.1 500 MHz, Software FP emulation cpu1: cache L1-I 32KB 4 way D 8KB 64 way, L2 128KB 8 way clock0 at mainbus0: int 5 iobus0 at mainbus0 simplebus0 at iobus0: "soc" octciu0 at simplebus0 cn30xxsmi0 at simplebus0 com0 at simplebus0: ns16550a, 64 byte fifo com0: console dwctwo0 at iobus0 base 0x1180068000000 irq 56 usb0 at dwctwo0: USB revision 2.0 uhub0 at usb0 configuration 1 interface 0 "Octeon DWC2 root hub" rev 2.00/1.00 addr 1 octrng0 at iobus0 base 0x1400000000000 irq 0 cn30xxgmx0 at iobus0 base 0x1180008000000 cnmac0 at cn30xxgmx0: RGMII, address dc:9f:db:80:0f:39 atphy0 at cnmac0 phy 7: AR8035 10/100/1000 PHY, rev. 2 cnmac1 at cn30xxgmx0: RGMII, address dc:9f:db:80:0f:3a atphy1 at cnmac1 phy 6: AR8035 10/100/1000 PHY, rev. 2 cnmac2 at cn30xxgmx0: RGMII, address dc:9f:db:80:0f:3b atphy2 at cnmac2 phy 5: AR8035 10/100/1000 PHY, rev. 2 /dev/ksyms: Symbol table not valid. uhub1 at uhub0 port 1 configuration 1 interface 0 "Terminus Technology USB 2.0 Hub [Safe]" rev 2.00/1.11 addr 2 umass0 at uhub1 port 2 configuration 1 interface 0 "Verbatim STORE N GO" rev 2.00/11.00 addr 3 umass0: using SCSI over Bulk-Only scsibus0 at umass0: 2 targets, initiator 0 sd0 at scsibus0 targ 1 lun 0: <Verbatim, STORE N GO, 1100> SCSI0 0/direct removable serial.18a50302103744VCIXG1 sd0: 7620MB, 512 bytes/sector, 15605760 sectors vscsi0 at root scsibus1 at vscsi0: 256 targets softraid0 at root scsibus2 at softraid0: 256 targets boot device: sd0 root on sd0a (80bf465f2582c4de.a) swap on sd0b dump on sd0b WARNING: No TOD clock, believing file system. WARNING: CHECK AND RESET THE DATE! cpu1 launched umodem0 at uhub1 port 1 configuration 2 interface 1 "SAMSUNG SAMSUNG_Android" rev 2.00/4.00 addr 4 umodem0: data interface 2, has no CM over data, has no break umodem0: status change notification available ucom0 at umodem0 ugen0 at uhub1 port 1 configuration 2 "SAMSUNG SAMSUNG_Android" rev 2.00/4.00 addr 4 ucom0 detached umodem0 detached ugen0 detached urndis0 at uhub1 port 1 configuration 1 interface 0 "SAMSUNG SAMSUNG_Android" rev 2.00/ff.ff addr 4 urndis0: using RNDISurndis0: IOERROR urndis0: unable to get query response : unable to get hardware address urndis0 detached umodem0 at uhub1 port 1 configuration 2 interface 1 "SAMSUNG SAMSUNG_Android" rev 2.00/4.00 addr 4 umodem0: data interface 2, has no CM over data, has no break umodem0: status change notification available ucom0 at umodem0 ugen0 at uhub1 port 1 configuration 2 "SAMSUNG SAMSUNG_Android" rev 2.00/4.00 addr 4 ucom0 detached umodem0 detached ugen0 detached urndis0 at uhub1 port 1 configuration 1 interface 0 "SAMSUNG SAMSUNG_Android" rev 2.00/ff.ff addr 4 urndis0: using RNDISurndis0: IOERROR urndis0: unable to get query response : unable to get hardware address urndis0 detached