On 2020-07-07 08:50, Stefan Sperling wrote:
> The diff has since been committed. Could you try a snapshot just
> to see if that works?
I pulled down the latest snap (#290 Jul 6 15:31:39 according to
dmesg), rebooted into it and grabbed a shell, then issued
# ifconfig athn0 debug nwid "$MYSSID" wpakey "$MYKEY" up
and got largely the same output as before, eventually hitting
athn: associated with {MAC} ssid "{MYSSID}" channel 3 start 1Mb short
preamble short slot time
and getting through all 4/4 of the 4-way handshake, and doing 1/2
and 2/2 fo the group key handshake, stopping at the
athn0: sending msg 2/2 of the group key handshake to {MAC}
This is further than 6.7 was getting (6.6 got this far). However,
the output stops there. An ifconfig says (hand transcribed)
athn0: flags=8847<UP,BROADCAST,DEBUG,RUNNING,SIMPLEX,MULTICAST> mtu 1500
lladdr {mymac}
llprio 3
groups: wlan
media: IEEE802.11 autoselect (DS1 mode 11g)
status: active
ieee80211: nwid {myssid} chan 3 bssid {routermac} -43dBm wpakey wpaprotos
wpa2 wpaakms psk wpaciphers ccmp wpacgroupcipher ccmp
About hourly(?) since issuing those, my console has given me another
pair of
athn0: received msg 1/2 of the group key handshake from {router MAC}
athn0: sending msg 2/2 of the group key handshake to {router MAC}
if that matters, though it seems successful.
On 6.6, after getting that successful 2/2-group-key-handshake,
issuing `dhclient athn0` would get me a connection but trying it on
this snap gives me the same as 6.7
# dhclient athn0
athn0: no lease....... sleeping
If you need further information, I can do my best to provide it.
> Lacking any better ideas I may try to install i386 on an APU and
> see if I can still reproduce it then...
My offer to rebuild with debugging patches holds as well if needed.
Thanks again!
-tim
