Dear OpenBSD developers,
I tried to run OpenBSD 6.9 on an Intel NUC 11 (NUC11TNKv7). Install runs
fine except Network Interface iwx0: could not read firmware iwx-quz-...
iwx0: failed to load init firmware
iwx0: aquiring device failed
After sucessful istall the screen goes blank while booting for the first
time. This is very likly related to IntelDRM. And should be solved via
boot> boot -c UKC> disable inteldrm UKC> quit
BUT the keyboard does not work at the UKC prompt. There is no legacy
support anymore for Intel NUC 11 (only UEFI). So there is no possibilty
to type UKC commands.
Regards,
Bernhard
