Hi All, I am using the Busybox (v1.7.1) in my root file system, I need to configure some default IP addresses to all my connected Ethernet interfaces when my system comes up. To achieve this I have done the following:
I have created a file "/etc/network/interfaces" auto lo iface lo inet loopback auto eth0 iface eth0 inet static address 172.17.4.105 netmask 255.255.0.0 gateway 172.17.1.10 When I run ifup -a, it shows me ifup: interface lo already configured ifup: interface eth0 already configured But there is no IP address is assigned to the interfaces, do I need to do something else also? When I assign the IP address manually to my interfaces it works fine. One more doubt, when I run, ifconfig eth0 up, I get the following outcome. # ifconfig eth0 up [ 120.552835] e1000: eth0: e1000_request_irq: Unable to allocate MSI interrupt Error: -22 But it seems to be a harmless error to me as I can assign the IP to my interface and it works, so any input why this warning message is coming will also be very helpful to me. Regards Rajeev Bansal. ******************************************************************************** This email message (including any attachments) is for the sole use of the intended recipient(s) and may contain confidential, proprietary and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please immediately notify the sender by reply email and destroy all copies of the original message. Thank you. Intoto Inc. _______________________________________________ busybox mailing list [email protected] http://busybox.net/cgi-bin/mailman/listinfo/busybox
