You might now add a length of wire, with the 50ohm resistor on place and see if a CQ will show up on the RBN.
73 Mark K5MGJ > On Mar 11, 2018, at 11:35 AM, Jon “KF5TFJ” Noxon via BVARC <bvarc@bvarc.org> > wrote: > > Gang, > > Friday after pulling out the HFB ][ built the night before, I could not get > it to work with my Nano Keyer project. But despair not, as I found the > solution… > > I replaced the optocoupler 4N43 with a MCT6, and now it works! The N43 did > not cause any issues with my KX3, but apparently the forward voltage drop was > a bit too much for the HFB ][. > > Jon > _______________________________________________ > BVARC mailing list > BVARC@bvarc.org > http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org > Message delivered to k5...@yahoo.com _______________________________________________ BVARC mailing list BVARC@bvarc.org http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org Message delivered to arch...@mail-archive.com