Rudy, I was at ACE Electronics last week. They did not have a large selection but they did have the toroid you were needing as well as the other stuff. I built a 9:1 for my end fed wire antenna. They did not have the Toroid I was needing but did have a reasonable selection at the time. I found the one I was needing from a buddy who happened to have one.
Good Luck, 73 - Mike - W7QAG -----Original Message----- From: BVARC [mailto:[email protected]] On Behalf Of Rudolph Ackerman via BVARC Sent: Tuesday, May 3, 2022 9:34 AM To: [email protected] Cc: Rudolph Ackerman Subject: [BVARC] Looking for parts to build a Balun OK where do you get your supply's to build your antenna's and parts? I looking to build a 4:1 Balum FT-240-43 Ferrite Toroid 3M Glass Cloth Electrical Tape 27 PTFE 18 awg wire (2 colors) Open to other options. Do you have a source for good PTFE 18 awg wire (or other options) that sales it by the foot. Not looking to buy a whole roll as I just dont need that much Thanks Rudy Ackerman KF5QYG ________________________________________________ Brazos Valley Amateur Radio Club BVARC mailing list [email protected] http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org Publicly available archives are available here: https://www.mail-archive.com/[email protected]/ ________________________________________________ Brazos Valley Amateur Radio Club BVARC mailing list [email protected] http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org Publicly available archives are available here: https://www.mail-archive.com/[email protected]/
