Nice! :)

Darren
W5AKC
________________________________
From: BVARC <[email protected]> on behalf of M Reiter via BVARC 
<[email protected]>
Sent: Thursday, February 16, 2023 12:25:27 PM
To: BRAZOS VALLEY AMATEUR RADIO CLUB <[email protected]>
Cc: M Reiter <[email protected]>
Subject: [BVARC] its official.

Yes I can now say with certainty that all antenna science is actually just 
VooDoo.
after reading 100s of pages on an equal number of antenna configurations I have 
determined that the only common denominator is that antennas must be made from 
metal. and someone will let me know that is also not so.   to sum up my 
research you must have a 1/4, 1/2, 5/8, 3/8, 3/4 full wavelength section at 
some angle to something else that is larger or smaller than the original  it 
must be between touching the earth or 200ft high whichever you like more.  it 
should be horizontal or vertical or an angle in-between.  can be made from wire 
or tubing of copper or aluminum but do not rule out magnesium.  it must be an 
open or closed circuit it definitely should or should not be resonate, SWR is 
bad, but a little is ok.   dont forget to trim your antenna until you have 
trimmed too much then add some back and trim some more. A balun unun 
unbalunousbulbulous, is absolutely maybe required but dont use one, they are 
rings of mystery metal called ferite, because they may be ferous and may be 
magic, they should be wound clockwise or counter clockwise or both and may have 
2 but can have as many as six wires in a mystical configuration that can not be 
shown in 2 dimensions. did i mention the magic ladder wire or 75-400 or more 
ohm coax with or without loops to make something called ohms all nice and 
matchy matchy. (oof course you dont need this either because radios do this for 
you.)

so there you have it,  all you need to know to get out there and make a perfect 
antenna.

Marc
Zombie Ham Operator, ki5ZHO
________________________________________________
Brazos Valley Amateur Radio Club

BVARC mailing list
[email protected]
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
Publicly available archives are available here: 
https://www.mail-archive.com/[email protected]/ 

Reply via email to