Also, check out:
https://www.earchi.org/92011endfedfiles/Endfed6_40.pdf
On Wednesday, August 21, 2024 at 07:23:20 AM CDT, David Holden via BVARC
<[email protected]> wrote:
If you are trying to build an end feed half wave (EFHW) antenna, the length is
in the name. A half wave at 40m is ~66 feet. Start with 67 feet and fold back
the end until you get a good SWR. You need a 49:1 transformer on one end to
get the impedance down to 50 ohm and to connect your coax. Mine is resonant at
10 through 40m.
David WJ9O
> On Aug 20, 2024, at 11:54 PM, Suggs, Marvin (KTRK-TV) via BVARC
> <[email protected]> wrote:
>
> Hey everybody
> I’m looking for a diagram and dimensions for a 40 meter end fed sloper
> antenna. Not having much luck on YouTube.
> Thanks
> Marvin
> N5RKW
> Sent from my iPhone
> ________________________________________________
> Brazos Valley Amateur Radio Club
>
> BVARC mailing list
> [email protected]
> http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
> Publicly available archives are available here:
> https://www.mail-archive.com/[email protected]/
________________________________________________
Brazos Valley Amateur Radio Club
BVARC mailing list
[email protected]
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
Publicly available archives are available here:
https://www.mail-archive.com/[email protected]/
________________________________________________
Brazos Valley Amateur Radio Club
BVARC mailing list
[email protected]
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
Publicly available archives are available here:
https://www.mail-archive.com/[email protected]/
