On Oct 26, 2007, at 3:46 AM, Andrea Lanza wrote:
> I also have ggod result using ht.386 and wellgate 3702.
> Setting up these ata is a bit non-linear, so you have to take care
> about
> settings.
Hi Andrea,
I have a feeling it is settings. Can you tell me more about what you
had to take care about when getting the settings correct?
What about my sip.conf entry?
; grandstream unit 1 line 1
[grandstream11]
type=friend
secret=grandstream11
context=from-internal-sip ; the internal context controls what
we can do
nat=no ; This phone is not natted
host=dynamic ; This device registers with us
defaultip=192.168.1.227 ; is fixed IP -- but not using host since
callweaver complained
; host=192.168.1.227 ; This device registers with us
canreinvite=yes ; allow RTP voice traffic to bypass OpenPBX
; dtmfmode=inband ; Choices are inband, rfc2833, or info (sjphone
needs inband) otherwise trial and errpr
dtmfmode=info ; either RFC2833 or INFO for the BudgeTone
[EMAIL PROTECTED] ; Activate the message waiting light if this
callerid="Dan" <104> ; my caller ID
disallow=all
allow=ulaw
>
> moreover, download and install latest firmware: you can download
> the zip,
> explode it into a pumpkin server (i.e)
> and then upgrade firmware via tftp
> HT.386
> Program-- 1.0.3.96 Bootloader-- 1.1.0.1 HTML-- 1.0.3.96 VOC--
> 1.0.0.13
>
I have already updated to the latest firmware as you mention above
but it did not help.
>
> Actually I leave all these ata on for weeks with no problems
If i don't use the ATA for "a while", when i make a test call to the
one of the lines i go right to voicemail since callweaver gets a
message that the line is busy as evidenced from the callweaver cli:
-- Called grandstream11
-- Got SIP response 486 "Busy" back from 192.168.1.227
-- SIP/grandstream11-2428 is busy
In this same state, if i pick up the handset on the analog phone on
the ATA i hear a click but i get no dial tone. Curious is that if i
put the handset down, then pick it up again i get a dial tone and if
i then hang up the hand set i can call the phone on the ATA and it
rings.
Have you seen any of these problems while you were working on getting
your settings correct?
Peace,
Dan
_______________________________________________
Callweaver-users mailing list
[email protected]
http://lists.callweaver.org/mailman/listinfo/callweaver-users
