I think I understand your 'Step 2'.
Can you break down 'Step 1' for me?
I have done nothing but bridging so far with these. So it is kind of a
special use case.
On 07/21/2017 03:12 PM, George Skorup wrote:
Configure the VLANs on your switch/router. Enable VLAN on the AP and
configure for your environment/prefs.
Configure NAT mode on the SM. Set default port VID on the VLAN config
page. The SM's NAT WAN interface will be on that VLAN on the RF side
and come out of the AP's ethernet interface tagged.
On 7/21/2017 1:26 PM, Ethan E. Dee wrote:
Is there a way to put a VLAN interface on the WLAN side of a PMP450i
900mhz? And then nat through the radio so that LAN port hands off a
private IP? Played around with it about an hour and couldn't get it.
Obviously missing something.
--
Ethan Dee
Network Admin
Globalvision
864 704 3600
[email protected]
For Support:
[email protected]
864 467 1333
For Sales:
[email protected]
864 467 1333
--
This message has been scanned for viruses and dangerous content by
*E.F.A. Project* <http://www.efa-project.org>, and is believed to be
clean.
_______________________________________________
Cambium-users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/cambium-users
_______________________________________________
Cambium-users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/cambium-users
--
Ethan Dee
Network Admin
Globalvision
864 704 3600
[email protected]
For Support:
[email protected]
864 467 1333
For Sales:
[email protected]
864 467 1333
_______________________________________________
Cambium-users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/cambium-users
