> Greetings! I am a new member and boy, am I glad to find support and
> help for the "old" Rvs. I have a couple questions.
The one thing I am going to do is change the split rims for
> solid. My question is this.........
If you were able to change from dual wheels on the rear axle to
single wheels, it would be the first time I heard of it being done.
Normally any chassis with dual wheels on the rear has a substantial
offset of the wheels surface that mounts to the hub. This is so that
the two wheels can be mounted and not touch. Since most all light
truck chassis have the same type of wheel for the front and rear
axles, means the front hubs need to accomodate the same offet, and are
therefore totally different from hubs that would be used with a
chassis having single rear wheels; where the offset is a lot less.
The other differences of course have to do with the weight bearing
capacity of the wheels and the tires that fit them.
First you need to determine what chassis your Avco is on. It
would likely have been either a Dodge or Chevy, or possibly Ford.
Once you know which you can find manuals for that type of chassis, and
see what the possibilities are for upgrading to the single piece
wheels, instead of the split rims. The VIN number would be one way
to learn. The Dodge vin chassis vin numbers at the time started with
an M. An M3xxxxxx would be an M300. If the VIN begins with a C then
it is a Chevvy. It is also possible the registration used the VIN
number created by Avco - in which case you would need to examine the
engine and chassis itself to learn who built it. If it was a Dodge
chassis, you will find the Chrysler pentagonal symbol scattered around
things on the engine - like the air cleaner, some of the castings,
etc. If you find the Chevy Chevron on anything on the motor, then its
a Chevvy chassis.
And if it is a Dodge chassis, as a majority of the motorhomes were
in the early 70s, there is a very good support group for old dodge
based motorhomes at www.classicwinnebago.com. That is a redirector
to the MSNgroups site.
There are almost certainly one-piece wheels to fit your chassis. If
your wheels are 8 bolt 16 inch, then the one pieces wheels probably
take 17.5 inch tires and arent too hard to find. If your wheels are 5
bolt 17 inch, then the one piece wheels that would fit would take 19.5
inch tires, and they are more pricey.
And unfortunately, there are more than one type of 8 bolt wheels, of
different ratings, in styles for rear axles with both the dual wheels
and the single wheels. They are not interchangeable.
My 72 winnebago has the 5 bolt 17 inch split rims, and I prefer
them. If you have more questions, my email is denisond3 -at-
hotmail. com. Except type the upper case 2 in place of the -at- and
dont have any spaces in the address.
| Yahoo! Groups Sponsor | |
|
|
Yahoo! Groups Links
- To visit your group on the web, go to:
http://groups.yahoo.com/group/classicrv/
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
