Good morning,
On 19/08/10 at 9:12 AM -0700, Bryan Opfer <[email protected]> wrote:
I have the same exact behavior in my app after upgrading to 0.14. So,
I don't think it is just your app. Interestingly, if I remove "param"
from my config and use the mode where the session id is appended to
the URI, then things work fine. But, if I use the session id in the
param, it breaks just like your app.
We're hitting the same thing then. I've just been playing with
C::P::Session::State::URI code and found that if I change line
323 from:
if ( my $sid = $c->request->param($param) ) {
to:
if ( my $sid = 0 ) {
then the problem goes away. So without knowing more about Cat
internals I would conclude that calling $c->request->param
during `prepare_path` is creating problems elsewhere. I also tried:
if ( my $sid = $c->request->parameters->{$param} ) {
And that fails as well.
I've tried following the code logic but I'm quickly getting lost
in all the different prepare_* methods spread among Catalyst.pm
and the different C::Engine modules.
For now I've changed C::P::Session::State::URI with `sub
prepare_action {...]` rather than `prepare_path` and my app is
working. Hopefully someone with some better ideas than me can
suggest what the proper fix is.
Charlie
--
Ꮚ Charlie Garrison ♊ <[email protected]>
O< ascii ribbon campaign - stop html mail - www.asciiribbon.org
〠 http://www.ietf.org/rfc/rfc1855.txt
_______________________________________________
List: [email protected]
Listinfo: http://lists.scsys.co.uk/cgi-bin/mailman/listinfo/catalyst
Searchable archive: http://www.mail-archive.com/[email protected]/
Dev site: http://dev.catalyst.perl.org/
