Hi group,
While going through my configs and comparing with the PG I found something which I do not understand. Its about task 2.1 regarding the part Do not automatically errdisable ports if there is a channel-group error. The PG tells to use the command: no spanning-tree etherchannel guard missconfig But if I apply that, and then check the errdisable-detect table, channel-missconfig is still enabled, see partial output below: Cat3550-2#sh errdisable detect ErrDisable Reason Detection Mode ----------------- --------- ---- arp-inspection Enabled port bpduguard Enabled port channel-misconfig Enabled port To me, this command only tells the router not to display an error message once a channel missconfig has been detected. The following descripiton can be found on the command lookup tool: To display an error message when a loop due to a channel misconfiguration is detected, use the spanning-tree etherchannel guard misconfig command in global configuration mode. To disable the error message, use the no form of this command. So could please someone clarify that? regards Roger
